Electrolux · independent service
Electrolux Appliance Repair in Tampa
Front-loaders, French-door refrigerators, dishwashers, ranges and wall ovens from Electrolux, older ICON columns included, repaired by an independent shop.
Booking online? The Electrolux's model tag in the notes helps us line up the right part.
Two short steps: what needs fixing and where, then your contact details. We get back to you to set a time.
Makes we work on
Electrolux Service for Houses, Condos and Rentals
Electrolux, based in Sweden, has owned Frigidaire since 1986, when it acquired Frigidaire's parent, White Consolidated Industries. In the North American lineup, Electrolux-branded appliances are positioned over Frigidaire, with plenty of common hardware underneath: refrigerator sealed systems, dishwasher pumps, range parts. That overlap works in your favor at repair time, because the failure patterns are well documented and many parts fit both brands. We have no tie to Electrolux, and warranty work belongs with the maker while the coverage lasts.
How a Repair Visit Works
Book the Visit
Tell us the appliance, its maker and the symptom. A photo of the model plate saves a step.
Find the Fault
We test the likely parts on site, along with the power, water or venting the appliance depends on.
Your Go-Ahead
We explain what failed and quote the repair. Nothing is done until you agree to the price.
Fixed and Verified
We install the part matched to your model, then run it to make sure the problem is gone.
You Might Also Need
Nearby areas, related brands and other equipment we service.
Which Electrolux Appliance Needs Work?
Electrolux Refrigerator
Repair page →
Electrolux Washer
Repair page →
Electrolux Dryer
Repair page →
Electrolux Dishwasher
Repair page →
Electrolux Oven
Repair page →
Electrolux Microwave
Repair page →
Electrolux Freezer
Repair page →
Electrolux Cooktop
Repair page →
Electrolux Stove
Repair page →
Electrolux Range
Repair page →
Where Electrolux shows up in Tampa
Electrolux is a common pick for kitchen and laundry upgrades that stop short of fully built-in luxury brands. Around Tampa Bay that means remodeled kitchens in Seminole Heights bungalows and South Tampa ranches, newer two-story homes in FishHawk and New Tampa, and condos where an owner bought a matched set.
The laundry pair is often in the garage, or upstairs in a newer home. A garage front-loader bakes in summer heat, and an upstairs one turns a small leak into a stain on the ceiling below, so drain hoses and supply lines get checked whenever we are there.
Shared engineering with Frigidaire
Many Electrolux refrigerators, ranges and dishwashers are built on platforms also used by Frigidaire Gallery and Professional models. Controls, finishes and features differ, but fans, igniters, elements, pumps and ice maker assemblies often share part numbers or close relatives.
Parts are still ordered against the full model and serial, since Electrolux has revised parts within a model's run and a near match is not always correct. ICON column refrigerators and freezers have been discontinued, so their electronics and trim can take longer to find.
Front-loaders, humidity and storms
Many Electrolux front-load washers use SmartBoost, which premixes detergent and water before it reaches the clothes, and all of them reward a little care. Humid air keeps the door boot, detergent drawer and pump filter damp, and mildew follows if the door stays shut between loads. A machine on an uneven garage slab walks and bangs in spin.
Lightning and the outages that follow summer storms are hard on electronic controls. A washer, dryer or range that went dark after a storm may only need a breaker reset, so we confirm power at the outlet before suspecting a board.
Electrolux appliance lines
- Refrigerators: French-door, counter-depth and side-by-side models, plus older ICON built-in columns. Frost in the door ice compartment, ice maker jams, fan noise, defrost failures and dispenser leaks are frequent.
- Washers: Front-load washers with steam and SmartBoost premixing, usually paired with a matching dryer. Door locks, drain pumps, torn boots, bearing noise and error-code shutdowns lead the list.
- Dryers: Vented electric and gas dryers with steam and sensor dry. Igniters and valve coils, heating elements, thermal fuses, drum rollers, belts and moisture sensors are the usual repairs.
- Dishwashers: Built-in dishwashers with stainless tubs. Drain pump blockages, wash motor faults, float switch trips, door latch problems and control errors are common.
- Ovens: Single and double wall ovens and oven-microwave combinations. Elements, convection fans, temperature sensors, door locks and controls cover most repairs.
- Microwaves: Over-the-range, built-in and drawer microwaves. No heat, bad interlock switches, turntables that stall, noisy hood fans and keypads that stop responding are the usual calls.
- Freezers: ICON all-freezer columns and upright freezers. Frost buildup, defrost heaters, fan motors, ice makers and door seals come up repeatedly.
- Cooktops: Gas, radiant and induction cooktops. The usual jobs are failed igniters and spark switches, burned-out radiant elements, induction power boards and broken glass.
- Stoves: Everyday Electrolux range trouble: gas burners that will not light, cold elements, ovens that never reach temperature and noisy convection fans.
- Ranges: Freestanding and slide-in ranges across gas, electric, dual-fuel and induction, often with convection and air fry. We replace a lot of oven igniters, bake elements, convection fans, sensors and self-clean locks.
Electrolux parts and sourcing
Electrolux and Frigidaire draw on the same North American parts system, and because so much is shared, common repairs are well supplied. Front-load tubs and bearings, ICON electronics and some trim pieces take longer, and a few are sold only bundled into bigger assemblies. The model and serial are recorded at the visit, the exact part is confirmed against them, and you are told honestly how long delivery is likely to take.
Electrolux visits are booked across Tampa and the wider Tampa Bay area; the list of areas and ZIP codes shows whether your street is covered.
Electrolux Repair FAQ
Short answers to what people usually ask before a visit. Anything not covered can go in the notes when you book.
Didn't see your question?
Send us the make, the model tag and what the appliance is doing. Some problems can be narrowed down before anyone drives over; most need hands on the machine.
Yes. Electrolux has owned Frigidaire since 1986, and the Electrolux-branded line shares platforms and many parts with Frigidaire's higher models. That generally helps parts supply and means the common faults are well known.
Mildew grows on water left in the boot, the detergent drawer and the pump filter, and humid weather helps it along. Prop the door and drawer open after each load, wipe the boot dry, run the cleaning cycle and drain the pump filter now and then. If the smell lingers anyway, we look for a slow drain or a torn boot.
Yes. ICON columns have been discontinued, but they are built-in units with their own controls and cooling systems, and the common faults are defrost, fans, ice makers and door alignment. We diagnose them in place and confirm parts supply before quoting.