Appliance Repair in Hudson & Bayonet Point (34667)

If your canal house was raised or rebuilt and the laundry ended up in the enclosure below, set the washer and dryer on a platform as high as the space allows. When a storm threatens, unplug both and shut the water valves. If water reaches that level, don't run either machine until it has been inspected, since surge water carries salt and sand into motors and boards.

Wind off the Gulf carries salt into Hudson and Bayonet Point, and outdoor equipment pays for it first: a lanai refrigerator's condenser fins, an ice maker on a covered patio, the flap on the dryer's wall vent. White crust on aluminum and rust spots on stainless are the early signs.

Unplug outdoor units and rinse their coils gently with fresh water every few weeks, and keep the dryer hood clear so the flap can close. Inside, vacuum the refrigerator's condenser behind the toe grille a couple of times a year.

In homes in Hudson and Bayonet Point that have taken water once, the next storm is the time to think about height. Pedestals under the washer and dryer, or a sturdy raised platform in the garage, keep motors and control boards above the first few inches of a flood.

The platform has to be solid and level, since a washer spinning on a wobbly base will walk off it. After raising a washer, check that the drain hose still reaches the standpipe without kinking and that the machine sits square.

The coastal side, including Hudson Beach, is in evacuation Zone A; Idalia in 2023 and Helene in 2024 both pushed Gulf water into homes there. Pasco draws its evacuation zones for storm surge from the Gulf, from Zone A on the canals inland to Zone E, and much of the county east of US 19 is in none of them. Surge mostly reaches the garage first, which is where many washers, dryers and spare freezers stand.

If salt water ever got into the garage or the laundry room, keep those appliances unplugged until they've been inspected. Salt keeps working on motor windings, wiring and control boards after the floor dries, so a machine that runs fine this week can fail next month.

Dryers in the manufactured homes around Hudson and Bayonet Point usually vent through the floor or a side wall over a short run of flexible duct. Push the dryer back and the duct folds; let lint build and the dryer runs hot and slow.

Pull the dryer out a few inches, straighten or replace the duct with a semi-rigid one, and clear the outside hood. If the drum still won't heat, the thermal fuse or element is next, and we test those on site.

In Hudson and Bayonet Point, county water reaches the refrigerator through a thin supply line and a small solenoid valve with a screen behind it. Minerals and the odd bit of sediment from the mains gather on that screen and in the filter, and the ice maker is the first to complain with small, hollow or clumped cubes.

Change the filter on the schedule in the manual, not when the light finally nags. If a fresh filter doesn't bring the cubes back, the fill valve or its screen is the next suspect, and low pressure at the refrigerator can look like the same fault. We check both before replacing anything.

Reach us by phone or through the booking page and tell us which appliance, its brand and what it's doing. If a refrigerator or freezer full of food in Hudson and Bayonet Point is the one failing, say that first.

Close by, also part of New Port Richey, Port Richey & Hudson: 34652 (New Port Richey & Gulf Harbors), 34653 (Elfers & New Port Richey East), 34654 (Moon Lake & River Ridge), 34655 (Trinity & Seven Springs), 34668 (Port Richey & Jasmine Estates) and 34669 (Shady Hills & Meadow Oaks).